1. Viewbed monitor label
The viewbed monitor lable allows you to select the viewbed monitor you want to view.
It displays the bed number and patient name of the viewbed monitor. If they are not
entered, the label displays blank. If the host monitor is not connected with any other
monitor on the same network, the label displays N/A.
2. Viewbed waveform label
The viewbed waveform label allows you to select a waveform of the viewbed monitor.
If the viewbed monitor does not dispaly any waveform, this label displays N/A.
3. Viewbed alarm indicator
The viewbed alarm indicator in the viewbed screen is used to indicate the alarm status
of the viewbed monitor. Its color is identical with that of the viewbed monitor.
4. Viewbed parameter area
All parameter data of the viewbed monitor is displayed in this area.
5. Viewbed waveform area
The viewbed waveform area is located beneath the viewbed waveform label. It
displays the waveform selected through the viewbed waveform label. The scan type
(either refresh or scroll) and the sweep speed of the viewbed waveform follow the host
monitor. Besides, information relating to the viewbed waveform is shown above the
waveform.
6. Technical information area
On the right of the viewbed monitor label is the technical information area. It shows
the technical information about viewing of other patient, such as the prompt
information indicating failure in viewing other patient due to network problems.
Automatic Selection
When the viewbed screen is opened, the host monitor automatically selects a viewbed
monitor on the same network and a waveform of this monitor to view. In case the monitor
being viewed is disconnected, the host monitor automatically closes the display of alarms,
parameters and the waveform of the viewbed monitor. However, the host monitor will not
automatically select to view other monitor. You must make the selection using the viewbed
monitor label manually.
If a parameter module of the viewbed patient monitor is turned off or disassembled, the
corresponding waveform displayed on the host monitor disappears, and the viewbed
waveform area becomes blank. At this time, you can use the viewbed waveform label to
view other waveform.
5-5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales