Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 218)

100

101

16.2 Measurement Procedure

WARNING

•

The accessories applied must meet the safety requirements for medical

instruments.

•

When the accessories are in use, avoid contacting conductive metal objects.

The following is the procedure to monitor patient’s cardiac output.

Connect the CO cable into the CO sensor connector of the monitor.

Connect the CO measurement catheter and the temperature probe correctly as shown in

Figure 16-2. The blood temperature reading is displayed.

Open the C.O. SETUP menu and adjust the parameters contained in this menu.

WARNING

•

Make sure that the computation coefficient for the measurement (CO.CONST,

see 16.3 CO Setup Menu for details) is appropriate to the catheter used.

NOTE

•

If the catheter is to be replaced, follow the instructions for the catheter and

input its calculation coefficient into the CO.CONST field in the CO setup menu.

4. Select the CO label in the CO parameter window, and the CO SELECT window pops up.

Then, select C.O. MEASURE to open the WINDOW FOR C.O. EDIT menu.

16-2

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 218

Comentarios a estos manuales