Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 297)

B EMC

The equipment meets the requirements of IEC 60601-1-2:2001.

NOTE

•

Use of accessories, transducers, and cables other than those specified may result

in increased emission and/or decreased immunity of the equipment.

•

The equipment should not be used adjacent to or stacked with other equipment,

and if adjacent or stacked use is necessary, the equipment should be observed to

verify normal operation in the configuration in which it will be used.

•

The equipment needs special precautions regarding EMC and needs to be

installed and put into service according to the EMC information provided

below.

•

The equipment may be interfered with by other equipment, even if that other

equipment complies with CISPR emission requirements.

•

Operation of the device, in the case that the patient physiological signal is lower

than the minimum amplitude and/or value specified in the product

specifications, may cause inaccurate results.

TABLE 1

Guidance and declaration — electromagnetic emissions

The equipment is intended for use in the electromagnetic environment specified below.

The customer or the user of the equipment should assure that it is used in such an

environment.

Emissions test Compliance Electromagnetic environment — guidance

RF emissions

CISPR 11

Group1 The equipment uses RF energy only for its

internal function. Therefore, its RF emissions

are very low and are not likely to cause any

interference in nearby electronic equipment.

RF emissions

CISPR 11

Class A The equipment is suitable for use in all

establishments other than domestic and those

directly connected to the public low-voltage

power supply network that supplies buildings

used for domestic purposes.

Harmonic

Emissions IEC61000-3-2

Class A

Voltage

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 297