Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 329)

AG module

AG STANDBY The AG module is in the standby

mode.

None

AG IS STARTING The AG module is starting. Wait for the AG module to

finish the startup.

AG WARM UP The AG module is warming itself up. Wait for the AG module to

finish warming itself up.

NIBP module

Manual measure... The NIBP module is performing the

manual measurement.

Wait for the NIBP module to

finish the measurement.

CONTINUAL... The NIBP module is performing the

continuous measurement.

Auto measuring... The NIBP module is performing the

auto measurement.

Resetting... The NIBP module is being reset. Wait the NIBP module to

finish the resetting. Resetting...

Please start This message appears after the auto

measurement interval is selected.

Press the NIBP button to start

the measurement.

CALIBRATE... The NIBP module is performing the

calibration.

Wait for the NIBP module to

finish the calibration.

Calibration over The calibration is finished. None

PNEUMATIC... The NIBP module is checking the

pneumatic system for leakage.

Wait for the NIBP module to

finish checking the pneumatic

system.

Pneum test over The NIBP finishes checking the

pneumatic system for leakage.

None

Measurement over The NIBP button is pressed during the

measurement.

None

Reset failed The reset fails. None

ST LEARNING The QRS complex template for the

ARR analysis is forming.

Wait till the end of the ARR

learning. ARR LEARNING

DEFIB. SYNC.ON The DEFIB. SYNC. switch is turned

on.

It indicates that the auxiliary

output port is outputting

DEFIB. SYNC. signals.

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 329

Comentarios a estos manuales