Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 104)

6.5 Clearing Alarms

Generally the alarm indications of an alarm will automatically be cleared when the alarm

condition that triggered the alarm ceases. However, you can also clear the alarm indications

or the latched alarms by the following ways.

1. Clearing audible and visual alarm indications

For some technical alarms, the audible and visual alarm indications will be cleared if the

monitor is set to the Alarms Paused status (by pressing the SILENCE key for less than 2

seconds), and the alarm message will be changed to prompt information during and after the

alarms paused time. If the technical alarm is triggered again after the monitor restores to the

normal status, the monitor will give alarming indications as normal.

Please refer to chapter Alarm Messages and Prompt Information to see for which technical

alarms that the audible and visual indications can be cleared.

2. Clearing all alarm indications

For some technical alarms, if the monitor is set to the Alarms Paused status (by pressing the

SILENCE key for less than 2 seconds), all alarm indications will be cleared during and after

the alarms paused time. If the technical alarm is triggered again after the monitor restores to

the normal status, the monitor gives alarming indications as normal.

Please refer to chapter Alarm Messages and Prompt Information to see for which technical

alarms that all alarm indications can be cleared.

3. Clearing latched alarms

Clearing latched alarms is also referred to as resetting alarms. It refers to clear the latched

alarms by setting the monitor to the Alarms Paused status (by pressing the SILENCE key

for less than 2 seconds).

6-8

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 104