Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 209)

100

101

HI: Determines the high scale. The reference scale changes when the high scale is

changed.

LO: Determines the low scale. The reference scale changes when the low scale is

changed.

VAL: Determines the reference scale and position. The high and low scales remain

unchanged when the reference scale is changed.

NOTE

•

The high scale should not be smaller than the low scale; the low scale should not

be larger than the high scale.

•

The waveform amplitude changes when the high and low scales are adjusted.

•

EXPAND PRESSURE Selecting this option opens the following menu. You can

select the pressure to be measured by P1 and P2.

Options: SYS, MEAN, DIA (three pressures are all

measured); MEAN (only the mean pressure is measured).

Figure 15-8 IBP Pressure Setup Menu

•

CONFIG >> You can select this option to access the IBP (1,2) CONFIG

menu, in which you may select FACTORY CONFIG or

USER CONFIG. After finishing your selection and exiting

the menu, the system pops up a dialog box asking for your

confirmation.

15-7

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 209

Comentarios a estos manuales