Shenzhen PM-9000 Express Manual del operador descargar pdf (Pagina 139)

100

101

NOTE

•

If the amplitude of an ECG waveform is too large, the peak of the waveform

might not be displayed. In this case, you should change the waveform gain

properly.

•

The selected leads of channel 1 and channel 2 should not be identical. Otherwise,

the system will change one of them automatically. In the MULTI-LEADS

DISPLAY mode or the HALF-SCN MUTLI-LEADS display mode, the leads of

both channels cannot be set.

ECG label

HR/PR

11.1.2 ECG Parameters

Heartbeat icon

Alarms Disabled icon

Figure 11-2 ECG Parameters

The parameters related to ECG are displayed to the right of the ECG waveforms as shown

above. The heartbeat indicator flashes in the same rate with the patient’s heartbeat or pulse.

The status of PACE, ST1, ST2, PVCs and NOTCH is shown at the right side of HR/PR

reading.

If your monitor is not configured with ST and ARR features, the numerics of ST1, ST2 and

PVCs will not be displayed.

11-3

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 338 339

Shenzhen PM-9000 Express Manual del operador Pagina 139

Comentarios a estos manuales